Chaque expert dans l'équipe de Pass4Test ont son autorité dans cette industrie. Ils profitent ses expériences et ses connaissances professionnelles à préparer les documentations pour les candidats de test Certification IT. Les Q&As produites par Pass4Test ont une haute couverture des questions et une bonne précision des réponses qui vous permettent la réussie de test par une seule fois. D'ailleurs, un an de service gratuit en ligne après vendre est aussi disponible pour vous.
Avec l'aide du Pass4Test, vous allez passer le test de Certification Cisco 642-611 plus facilement. Tout d'abord, vous pouvez choisir un outil de traîner de Cisco 642-611, et télécharger les Q&A. Bien que il y en a beaucoup de Q&A pour les tests de Certification IT, les nôtres peuvent vous donner non seulement plus de chances à s'exercer avant le test réel, mais encore vous feront plus confiant à réussir le test. La haute précision des réponses, la grande couverture des documentations, la mise à jour constamment vous assurent à réussir votre test. Vous dépensez moins de temps à préparer le test, mais vous allez obtenir votre certificat plus tôt.
Participer au test Cisco 642-611 est un bon choix, parce que dans l'Industire IT, beaucoup de gens tirent un point de vue que le Certificat Cisco 642-611 symbole bien la professionnalité d'un travailleur dans cette industrie.
Pass4Test est un site web qui vous donne plus de chances à passer le test de Certification Cisco 642-611. Le résultat de recherche sortis par les experts de Pass4Test peut assurer que ce sera vous ensuite qui réussirez le test Cisco 642-611. Choisissez Pass4Test, choisissez le succès. L'outil de se former de Pass4Test est bien efficace. Parmi les gens qui ont déjà passé le test, la majorité a préparé le test avec la Q&A de Pass4Test.
Code d'Examen: 642-611
Nom d'Examen: Cisco (CCIP Implementing Cisco MPLS Exam (MPLS))
Questions et réponses: 509 Q&As
Au 21er siècle, il manque encore grand nombreux de gens qualifié de IT. Le test Certificat IT est une bonne façon à examiner les hommes de talent. Ce n'est pas un test facile à réussir. Un bon choix de formation est une assurance pour le succès de test. Le test simulation est bien proche que test réel. Vous pouvez réussir 100%, bien que ce soit la première à participer le test.
Les produits de Pass4Test sont préparés pour le test Certification Cisco 642-611, y compris les formations et les informations ciblées au test Cisco 642-611. D'ailleurs, la Q&A de Pass4Test qui est impressionnée par la grande couverture des questions et la haute précision des réponses vous permet à réussir le test avec une haute note.
La solution offerte par Pass4Test comprenant un test simulation bien proche de test réel Cisco 642-611 peut vous assurer à réussir 100% le test Cisco 642-611. D'ailleur, le service de la mise à jour gratuite est aussi pour vous. Maintenant, vous pouvez télécharger le démo gratuit pour prendre un essai.
642-611 Démo gratuit à télécharger: http://www.pass4test.fr/642-611.html
NO.1 In the diagram, the Internet is accessed through a dedicated Internet VPN implementation.
Which routing table will PE-IG use to forward packets from the Internet to Site-2?
A.Global routing table
B.VPNv4 routing table
C.VRF A routing table
D.VRF Internet routing table
Correct:D
certification Cisco certification 642-611 642-611
NO.2 When nonadjacent LDP neighbors are used for implementing an MPLS traffic engineering
solution, how are the nonadjacent LDP neighbors discovered?
A.using multicast CR-LSP (constraint-based LSP)
B.using unicast CR-LSP (constraint-based LSP)
C.using multicast LDP hello messages
D.using unicast LDP hello messages
E.using multihop MP-IBGP
F.using multihop MP-EBGP
Correct:D
certification Cisco certification 642-611 642-611
NO.3 Which three statements are correct regarding Layer 2 overlay VPNs and peer-to-peer VPNs?
(Choose three.)
A.Peer-to-peer VPNs require the establishment of virtual circuits to connect the different customer sites
together.
B.Peer-to-peer VPNs require the service provider to participate in the customer routing, accepting
customer routes, transporting them across the service provider backbone, and finally propagating them to
other customer sites.
C.With peer-to-peer VPNs, the service provider is responsible for transport of Layer 2 frames between
customer sites, and the customer takes responsibility for all higher layers.
D.The implementation of Layer 2 overlay VPNs is the traditional switched-WAN model, implemented with
technologies like X.25, Frame Relay or ATM.
E.With Layer 2 overlay VPNs, the service provider is not aware of customer routing and has no
information about customer routes.
F.It is simple to implement Layer 2 overlay VPNs because the Customer Edge (CE) router just needs a
connection to the Service Provider's Provider Edge (PE) router.
Correct:B D E
certification Cisco certification 642-611 642-611
NO.4 Which kind of link does a Layer 3 overlay VPN use?
A.emulated point-to-point
B.dedicated point-to-point
C.point-to-multipoint
D.permanent virtual circuits
Correct:A
certification Cisco certification 642-611 642-611
NO.5 Refer to the exhibit. A diagram of a router connected to an MPLS-enabled ATM switch via an
LC-ATM MPLS interface, and a partial configuration for the MPLS-enabled ATM switch and router
are shown. Which statement describes what is incorrect about the configuration shown?
A.CEF has not been enabled on the router.
B.The VPI range of 2-3 is invalid.
C.The control VPI/VCI has not been set to 0/32 on the router.
D.VC-merge has not been enabled on the ATM switch interface.
E.The router has not been configured to specifically use LDP.
Correct:A
certification Cisco certification 642-611 642-611
NO.6 Refer to the exhibit. Based on the show outputs, which condition could be preventing the P1
router from establishing TDP adjacency with its neighbor over the s0/0.211 and s0/0.212
subinterfaces?
A.The s0/0.211 and s0/0.212 subinterfaces line protocol are in the down state.
B.The P1 router cannot establish a TCP session with its neighbors.
C.The P1 router is missing the mpls label protocol LDP command.
D.The show mpls tdp neighbor command needs to be used to view the TDP neighbor status.
Correct:B
certification Cisco certification 642-611 642-611
NO.7 What is a benefit of CEF switching?
A.CEF supports IP source prefix-based switching using the FIB.
B.CEF uses less memory than fast switching uses.
C.CEF is less CPU intensive than fast switching is.
D.CEF provides Netflow statistics with minimum CPU overhead.
E.CEF allows multiple data planes to share a common control plane.
Correct:C
certification Cisco certification 642-611 642-611
NO.8 In the diagram, Internet access is through a dedicated subinterface implementation. Which of
its routing tables will PE-2 use to forward packets from Site-2 to Site-1?
A.the global routing table
B.the VPNv4 routing table
C.the VRF A routing table
D.the VRF A FIB
E.the PE-IG routing table
Correct:C
certification Cisco certification 642-611 642-611
NO.9 Refer to the exhibit. A diagram of a router connected to an MPLS-enabled ATM switch via an
LC-ATM MPLS interface, and the partial configuration for the MPLS-enabled ATM switch and
router are shown. Which statement describes what is incorrect about the configuration?
A.The control VPI/VCI numbers do not match.
B.The ATM VPI range of 2-3 is invalid.
C.CEF has not been enabled on the router ATM 3/0.2 subinterface.
D.VC-merge has not been enabled on the switch ATM 0/1/2 interface.
E.The router has not been configured to specifically use LDP.
Correct:A
certification Cisco certification 642-611 642-611
NO.10 Look at the picture.
Correct:
Green choice1---->Yellow Choice1
Green choice5---->Yellow Choice2
Green choice9---->Yellow Choice3
certification Cisco certification 642-611 642-611
NO.11 With MPLS VPNs, if the CE-PE routing protocol is BGP, which statement below is true?
A.The different customer sites must use different autonomous system numbers.
B.Manual route redistribution between EBGP and MP-BGP is required.
C.The SOO extended BGP community can be used to prevent routing loops.
D.A BGP virtual sham-link is required between the customer site's CE routers to ensure optimal routing
between the customer sites.
E.The customer's autonomous system number must match the MPLS VPN service provider's
autonomous system number.
Correct:C
certification Cisco certification 642-611 642-611
NO.12 What best describes the following configuration example of allowas-in? router bgp 100
address-family ipv4 vrf CustomerAneighbor 195.12.4.5 remote-as 123 neighbor 195.12.4.5
activateneighbor 195.12.4.5 allowas-in 2
A.permits incoming BGP updates defined by access-list 2
B.permits incoming BGP updates defined by class-map 2
C.permit incoming BGP updates defined by route-map 2
D.permits incoming BGP updates with no more than two occurrences of AS 100 in the AS path
E.permits incoming BGP updates with no more than two occurrences of AS 123 in the AS path
Correct:D
certification Cisco certification 642-611 642-611
NO.13 What is the difference in implementation between a managed CE services MPLS VPN and a
central services MPLS VPN?
A.RD assignment
B.selective routes export
C.selective routes import
D.MP-BGP route redistribution filtering
E.CE-PE routing process
F.none
Correct:B
certification Cisco certification 642-611 642-611
NO.14 BGP is used as the CE-PE routing protocol in an MPLS VPN. The customer routes are
successfully propagated from the CE router to the ingress PE router, but they are not showing up
on the egress PE router. What is the most likely cause of the problem?
A.There is a BGP-to-MPBGP redistribution error on the ingress PE router.
B.There is a MPBGP-to-BGP redistribution error on the egress PE router.
C.One of the P routers is performing route summarization, breaking the path between the ingress and the
egress PE routers into two LSPs.
D.RTs attached to the CE routes exported by the ingress router are not matched by at least one of the
import RTs on the egress PE router.
E.A route reflector is used to propagate the routes from the ingress PE router to the egress PE router,
thus breaking the LSP.
Correct:D
certification Cisco certification 642-611 642-611
NO.15 Refer to the exhibit. How many different VRFs are required to support the given connectivity
requirements? Sites CE1A and CE1B require connectivity to each other. Sites CE2A and CE2B
require connectivity to each other. Site CE1C requires connectivity to sites CE1A, CE1B, CE3A,
and CE3B. Site CE2C requires connectivity to sites CE2A, CE2B, CE3A, and CE3B. Sites CE3A and
CE3B require connectivity to each other and to CE1C and CE2C.
A.3 VRFs
B.4 VRFs
C.5 VRFs
D.6 VRFs
E.8 VRFs
Correct:C
certification Cisco certification 642-611 642-611
NO.16 Refer to the diagram. What problem can be caused by the second P router summarizing the
loopback address of the egress PE router?
A.The first P router will be faced with a VPN label which it does not understand.
B.The second P router will be faced with a VPN label which it does not understand.
C.The egress PE router will not be able to establish a label switch path (LSP) to the ingress PE router.
D.A label switch path (LSP) will be established from the ingress PE router to the egress PE router, an
event that is not desirable.
E.The ingress PE router will not be able to receive the VPN label from the egress PE router via MP-IBGP.
Correct:B
certification Cisco certification 642-611 642-611
NO.17 What are three characteristics of overlay VPNs? (Choose three.)
A.Service provider infrastructure appears as point-to-point links to the customer routers.
B.Routing protocols run directly between the customer routers.
C.Implementing optimum routing between customer sites requires a partial mesh of virtual circuits.
D.Service provider PE routers use route filtering to isolate between different customers.
E.Service provider does not participate in customer routing.
Correct:A B E
certification Cisco certification 642-611 642-611
NO.18 What is a major drawback of using traditional IP routing over an ATM network when connecting
multiple sites?
A.Each ATM switch in the path has to perform Layer 3 routing lookup.
B.ATM virtual circuits have to be established between the different sites.
C.There is high ATM management overhead between the ATM switch and the router at each site.
D.Each ATM switch has to be manually configured to participate in Layer 3 routing.
E.There is high PNNI overhead.
Correct:B
certification Cisco certification 642-611 642-611
NO.19 Look at the picture.
Correct:
Green choice1---->Yellow Choice1
Green choice6---->Yellow Choice2
Green choice2---->Yellow Choice3
Green choice5---->Yellow Choice4
Green choice3---->Yellow Choice5
Green choice4---->Yellow Choice6
certification Cisco certification 642-611 642-611
NO.20 Lab.
Correct:
certification Cisco certification 642-611 642-611
Pass4Test a une équipe se composant des experts qui font la recherche particulièrement des exercices et des Q&As pour le test certification Cisco 642-611, d'ailleurs ils peuvent vous proposer à propos de choisir l'outil de se former en ligne. Si vous avez envie d'acheter une Q&A de Pass4Test, Pass4Test vous offrira de matériaux plus détailés et plus nouveaux pour vous aider à approcher au maximum le test réel. Assurez-vous de choisir le Pass4Test, vous réussirez 100% le test Cisco 642-611.
没有评论:
发表评论